Performance Suspension Lift Brackets

These units are very heavy duty, more so than the original tubes. Cutting the old units as required in the instructions is no easy task though!! Be forewarned. My sawsall with Dewalt TP14 or TP18 metal blades was a slow go at best, and I went through quite a few blades. I found it easier to use my Dremel to cut 60% (three of the 4 corners) of the bar where I could reach (inner wheel, bottom) then do the rest with the sawsall. I cut the factory nuts off with the Dremel as well, but they were easy compared to the bar. As I noted they units themselves are very heavy duty, and give more than ample clearance for tires. If your tires rub, it is not on these, but probably other parts of the fender/trim. The design tucks these bar away quite well.